Capabilities
One building, from wax pattern to finished part.
Nothing goes out for heat treat, inspection or machining, which keeps lead times short and puts one team on the hook for the whole part.
Part weight
0.1 to 40 lb
Melt
Air induction, 500 lb heats · Vacuum induction, 150 lb heats (IN718)
Shell
Robotic dip cell, 7 to 9 coats, climate-controlled drying
Heat treat
In house, by alloy: solution and age, harden and temper, or solution anneal
NDT
Fluorescent penetrant and radiography, per drawing and purchase order
Inspection
Bridge CMM for castings · Second CMM for machined features
Machining
5-axis vertical and horizontal machining centers
The process
A representative route for a 17-4PH aerospace part. Other part families differ in heat treat, NDT and machining.
- 1
Wax injection
Patterns are shot in aluminum dies on four wax presses. Some dies are customer-owned and stored here.
- 2
Tree assembly
Patterns are attached to sprues and gates to form a tree.
- 3
Shell building
A robotic dip cell builds 7 to 9 ceramic coats, with 4 to 6 hours of drying per coat in a humidity- and temperature-controlled room.
- 4
Dewax
A steam autoclave melts the wax out of the shell.
- 5
Burnout and preheat
Two furnaces fire the shells and bring them to pour temperature.
- 6
Melt and pour
Air induction melting up to 500 lb per heat. Vacuum induction melting up to 150 lb for IN718.
- 7
Knockout, cut-off, grind
Shell is removed, castings come off the tree, and gates are ground flush.
- 8
Heat treat
By alloy, in our own furnace: solution and age for 17-4PH, harden and temper for CA6NM, solution anneal for CF8M and CF3M.
- 9
Straighten
When a part needs it, before inspection.
- 10
NDT
Methods, coverage and stage per drawing and purchase order, including after final machining when required. Typically fluorescent penetrant, plus radiography on aerospace work.
- 11
Dimensional inspection
Castings are checked on a bridge CMM against datum pads A, B and C.
- 12
Machining
5-axis vertical and horizontal machining centers. Fixtures locate on the as-cast datum pads.
- 13
Final inspection
Machined features are checked on a second CMM. First article per AS9102 on new revisions.
- 14
Ship
With material certs and inspection reports.
Alloys
These are the alloys we pour every week. If yours is not here, ask anyway.
17-4PH (AMS 5355)
Precipitation-hardening stainless. Aerospace brackets and housings, orthopedic parts, robot joint housings. H1025 is our usual condition.
IN718 (AMS 5383)
Nickel alloy, vacuum melt only. High-temperature aerospace parts.
CF8M
Cast counterpart of 316 stainless. Pump and valve bodies for corrosive service.
CF3M
Cast counterpart of 316L. Surgical and orthopedic components.
CA6NM
Martensitic stainless. Impellers and valve trim that need strength and erosion resistance.